Hp NetRAID 1 Controller Bedienungsanleitung PDF herunterladen (Seite 33)

NetWare, OS/2, SCO and Vines: HP NetRAID

Config

Overview

HP NetRAID Config is a character-based, non-GUI utility that configures and monitors RAID

systems. HP NetRAID Config runs under the following operating systems:

• Novell NetWare 3.x, 4.xx, 4.xx SMP, SFTIII 4.1

• Banyan VINES 6.0 and 7.0

• IBM OS/2 Server 2.11, 2.11 SMP, and Warp SMP

• MS-DOS 3.2 or later

• SCO ODT 3.0, MPX 3.0, and OpenServer 5.0

NOTE These instructions in using HP NetRAID Config refer specifically to the Novell

NetWare network operating system. Specific features may not be available in all

network operating systems, and the exact location of specific menu options may

vary.

This section describes the following functions:

A. HP NetRAID Config NOS Starting Commands

B. HP NetRAID Config Management Menu Options

C. Configuring Arrays and Logical Drives

D. Initializing Logical Drives

E. Formatting Physical Drives

F. Exiting HP NetRAID Config

A. HP NetRAID Config NOS Starting Commands

To start HP NetRAID Config, make sure the program file is in your file path and type the command

corresponding to your network operating system, as listed in the following table.

Operating

System

HP NetRAID Config

Starting Commands

NetWare load megamgr

OS/2 megaconf

SCO UNIX megamgr

VINES 6.0, 7.0 megaconf

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 83 84

Keine Kommentare

Hp NetRAID 1 Controller Bedienungsanleitung Seite 33