HP EliteDesk 800 G3 Small Form Factor PC (ENERGY STAR) Bedienungsanleitung PDF herunterladen (Seite 46)

Installing a 3.5-inch hard drive

NOTE: There are two 3.5-inch hard drive bays. The procedure for installing a 3.5-inch hard drive is the same

for each drive bay.

1. Prepare the computer for disassembly (Preparation for disassembly on page 20).

2. Remove the access panel (Access panel on page 21).

3. Install mounting screws on the sides of the hard drive using standard 6-32 silver-and-blue mounting

screws.

NOTE: If replacing a 3.5-inch hard drive, transfer the mounting screws from the old hard drive to the

new hard drive.

If you are adding a second 3.5-inch hard drive, you can purchase extra mounting screws from HP.

●

Install four silver-and-blue 6-32 mounting screws (two on each side of the drive).

●

You can also install a 2.5-inch hard drive into a 3.5-inch drive bay using an adapter bracket similar

to the example shown below.

–

Slide the 2.5-inch drive into the 3.5-inch adapter bracket.

38 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 153 154

Keine Kommentare

HP EliteDesk 800 G3 Small Form Factor PC (ENERGY STAR) Bedienungsanleitung Seite 46