Hp OneView for VMware vCenter Bedienungsanleitung PDF herunterladen (Seite 33)

From the HP Management Administration page, select Server Module Configuration screen for the

cluster, enter the power cost. Entering the power cost for a cluster generates the cost advantage

information, which is displayed for each host on the Cluster detail page.

The Cost Advantage value is calculated as follows:

Cost Advantage = (number of hours the server was down) × (power cost) × (average power)

Entering the Power Cost will only calculate the Cost Advantage if all of the requirements in this

section are applicable for the cluster. If the requirements are not met by the cluster, the cost

advantage is always zero.

Bare-metal provisioning

Using the HP Management Deployment Wizard (vSphere Client)

The HP Management Deployment Wizard facilitates the deployment of the vSphere 5.x/ESXi 5.x

image using RDP by providing a drag-and-drop interface to deploy vSphere 5.x/ESXi 5.x from

the vSphere Client. You can also add the newly created hosts to a cluster or datacenter.

IMPORTANT: RDP is not supported with HP Insight Control 7.3 and later. To use the HP

Management Deployment Wizard for server deployment you must have HP Insight Control 7.2

installed.

Prerequisites

Before using the wizard, you must have installed the following:

• HP OneView for vCenter

• HP RDP from the HP Insight Rapid Deployment website.

NOTE: You must use the RDP-configured IP that was provided during the RDP installation.

• HP SIM credentials must be configured in HP OneView for vCenter

• HP Deployment Connector (included with HP OneView for vCenter)

NOTE: If you try to use the HP Management Deployment Wizard without installing the

Deployment Connector, the wizard prompts you to download and install it. Follow the on-screen

instructions.

The Deployment Connector installer is also available in the install

directory\uim\static\bin directory.

You must also create a job folder and use the RDP console to copy (drag and drop) corresponding

vSphere 5.x/ESXi 5.x images into that folder before you use HP OneView for vCenter deployment.

To use the HP Management Deployment Wizard:

1. Navigate to the vSphere Client home page.

2. Under Management, click HP Management Deployment Wizard.

The Step 1 – Choose Targets window opens.

3. Select each system to which you want to deploy vSphere 5.x/ESXi 5.x images, and then click

Next.

The Step 2 – Configure Networking window opens.

4. For the network interface, do one of the following, and then click Next:

• Select the DHCP check box.

• Enter a static IP address, network domain, gateway, and DNS server information.

The Step 3 – Deploy window opens.

Using the Server Module for vCenter 33

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 156 157

Keine Kommentare

Hp OneView for VMware vCenter Bedienungsanleitung Seite 33