Hp OneView for VMware vCenter Bedienungsanleitung PDF herunterladen (Seite 55)

• Preferred Path

P4000—Not applicable◦

◦ 3PAR—Not applicable

◦ P6000 EVA—Specifies whether the path uses a port on the controller that is configured

as the preferred path for the vdisk (Yes, No, No preference)

◦ P2000/MSA2000—Not applicable

◦ P9000/XP—Not applicable

• Active Path—Specifies whether the path is active or in standby status

If a path is active and then goes offline, a standby path takes over.

• Path ID—Path ID assigned by VMware

• VMware Disk Identifier—Disk name assigned by VMware

Viewing replications

The Replications tab is displayed in the HP Insight Management tab for selected hosts, clusters,

VMs, and datastores. See “Replications tab” (page 55)).

Figure 28 Replications tab

This tab displays the following information:

• Source Disk Name—Source replication disk

• Source Array—Array identifier for the local (source) array; displayed only for Continuous

Access replications and not supported for P2000/MSA2000 arrays

• Replication Type—The type of replication used:

P4000—Snapshot, Remote Snapshot◦

◦ 3PAR—Virtual copy, Physical copy

◦ P6000 EVA—Snapshot, Snapclone, Mirrorclone, Continuous Access

◦ P2000/MSA2000—Not applicable

◦ P9000/XP—P9000 or XP Business Copy, P9000 or XP Snapshot, P9000 or XP Continuous

Access

• Replica Name—Target replication disk

• Replica Array—Array identifier for the remote (target) array; displayed only for Continuous

Access replications and not supported for P2000/MSA2000 arrays

• Replica Status—Status of the replica (for example, PAIR, SUSPEND, or COPY)

Using the Storage Module for vCenter 55

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 98 99

Keine Kommentare

Hp OneView for VMware vCenter Bedienungsanleitung Seite 55