HP D8C84UT#ABA Bedienungsanleitung PDF herunterladen (Seite 71)

5. Slide the drive back until it stops, then lift it up and out of the drive cage.

Figure 7-29 Removing a 3.5-inch Drive (Media Card Reader Shown)

NOTE: When replacing a 3.5-inch drive, transfer the four mounting screws from the old drive to the

new one.

Installing a Drive into the 3.5-inch Internal Drive Bay

The 3.5-inch bay is located underneath the 5.25-inch drive. To install a drive into the 3.5-inch bay:

1. Follow the procedure in

Removing an Internal 5.25-inch Drive on page 57 to remove the 5.25-

inch drive and access the 3.5-inch drive bay.

CAUTION: Ensure that the computer is turned off and that the power cord is disconnected

from the electrical outlet before proceeding.

2. If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then

remove the bezel blank. See

Bezel Blanks on page 41 for more information.

3. Install three M3 metric mounting screws in the lower holes on each side of the drive: two on the

right side and one on the front left side. HP has provided extra M3 metric mounting screws on

the front of the chassis, under the front bezel. The M3 metric mounting screws are black. Refer

Installing and Removing Drives on page 55 for an illustration of the extra M3 metric mounting

screws location.

CAUTION: Use only 5-mm long screws as mounting screws. Longer screws can damage the

internal components of the drive.

NOTE: When replacing the drive, transfer the three M3 metric mounting screws from the old

drive to the new one.

Figure 7-30 Installing Mounting Screws in the Media Card Reader

Drives 63

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 159 160

Keine Kommentare

HP D8C84UT#ABA Bedienungsanleitung Seite 71