HP D8C84UT#ABA Bedienungsanleitung PDF herunterladen (Seite 64)

NOTE: If you are replacing the primary hard drive, you must remove the four silver and blue

6-32 isolation mounting screws from the old hard drive and install them in the new hard drive.

Figure 7-16 Extra Mounting Screw Locations

Table 7-3 Extra Mounting Screws

No. Mounting Screw Device

1 Black M3 Metric Screws All Drives (except hard drives)

2 Silver 6-32 Standard Screws Secondary Hard Drive (in systems supporting two hard drives)

There are a total of five extra silver 6-32 standard screws. Four are used as mounting screws for a secondary hard

drive (not supported). The fifth is used for bezel security (see

Front Bezel Security on page 88 for more

information).

CAUTION: To prevent loss of work and damage to the computer or drive:

If you are inserting or removing a drive, shut down the operating system properly, turn off the

computer, and unplug the power cord. Do not remove a drive while the computer is on or in standby

mode.

Before handling a drive, ensure that you are discharged of static electricity. While handling a drive,

avoid touching the connector.

Handle a drive carefully; do not drop it.

Do not use excessive force when inserting a drive.

Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields

such as monitors or speakers.

If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and

label the package “Fragile: Handle With Care.”

56 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 159 160

Keine Kommentare

HP D8C84UT#ABA Bedienungsanleitung Seite 64