HP EliteBook Folio 9480m Notebook PC Bedienungsanleitung PDF herunterladen (Seite 79)

Display assembly

This section describes removing components that require you to completely remove the display panel. For

more information about removing display components that do not require that you remove the assembly

from the computer, see Display assembly components (panel, bezel, webcam, microphone) on page 50.

NOTE: The display assembly is spared at the subcomponent level only.

Before removing the display assembly, follow these steps:

1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the

computer on, and then shut it down through the operating system.

2. Disconnect the power from the computer by unplugging the power cord from the computer.

3. Disconnect all external devices from the computer.

4. Remove the battery (see Battery on page 29), and then remove the following components:

a. Hard drive cover (see Hard drive cover on page 32)

b. Hard drive (see Hard drive/SSD drive on page 33)

c. Service cover (see Service cover on page 38)

d. WLAN module (see WLAN module on page 43)

e. WWAN module (see WWAN module on page 41)

f. Fan (see Fan on page 58)

g. Keyboard (see Keyboard on page 45)

h. Base enclosure (see Base enclosure on page 53)

Remove the display assembly:

1. Disconnect the display panel cable (1) from the system board.

2. Release the display panel cable from the routing channel (2).

3. Open the computer and position it with the base enclosure on a table and the display hanging down.

Component replacement procedures 67

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 135 136

Keine Kommentare

HP EliteBook Folio 9480m Notebook PC Bedienungsanleitung Seite 79