Hp LXR 8000 Bedienungsanleitung PDF herunterladen (Seite 42)

HP NetServer Installation Guide 28

LXr 8000 (with Fibre Channel)

These procedures provide instructions for servers using Fibre Channel shared storage solutions (HP Rack

Storage/12FC.

Configure NetServer Hardware and BIOS

1. System A and System B can both be powered on.

2. Insert the HP NetServer Navigator CD in the CD-ROM drive and restart the server.

3. During reboot enter the Setup Utility by pressing F2.

4. Select User Preferences and then the LH4 Integrated NetRAID setting you want to use.

5. Exit the Setup Utility (F10, Save, and Exit).

The server reboots. If you have special NetServer local SCSI bus options enter the Symbios utility, by

pressing Ctrl+C at the Symbios boot banner during reboot and set the options you need; otherwise allow

the server to reboot. The server boots from the CD and displays the Navigator Main menu.

NOTE If prompted that the HP NetServer Navigator BIOS is a newer version, choose

Continue and go to step 6; otherwise go to step 9.

6. To update the BIOS, choose Configuration Assistant and Installation Assistant,

then Custom, Microsoft, MS Windows NT 4.0 Enterprise Edition, and No for

automated NOS installation.

7. Select Update, then Execute. Follow screen prompts to update the BIOS.

8. After the server reboots, return to the Navigator main menu by clicking the Back button twice on the

displayed window.

9. From the Navigator main menu, install a utility partition on the local storage disk by choosing

Configuration Assistant and Installation Assistant, Custom, Microsoft,

then MS Windows NT4.0 Enterprise Edition Cluster Server.

10. Choose Install/Update Utility Partition.

When finished, the system reboots and displays the Custom Configuration window.

11. Make a NT4.0 Drivers floppy disk by choosing Create Driver Diskette(s), Execute, and

following the prompts. Label the floppy disk NT 4.0 Drivers.

12. Return to the Navigator main menu by clicking the Back button three times.

Install Windows NT

NOTE Windows NT must be installed from floppy disks, not the CD, so that the mass storage

drivers will be loaded correctly. If you have not created a set of Windows NT boot

floppy disks, see Software in part “1 What’s Needed” of the installation guide supplement

for additional information.

1. Insert the boot floppy disk for Windows NT4.0 and exit Navigator to reboot the server.

2. When Windows NT Setup prompts to detect mass storage devices, skip detection and manually specify

the mass storage drivers:

• The drivers are loaded from the NT 4.0 Drivers floppy disk you created from the Navigator CD.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 94 95

Keine Kommentare

Hp LXR 8000 Bedienungsanleitung Seite 42