Cooling strategies for IT equipment Technology brief Introduction ...
10 The HP MCS G2 supports the front-to-back cooling principle. It evenly distributes cold supply air at the front of each rack so components receive
11 HP MCS cooling requirements The HP MCS G2 adds minimal heat to the room because most of the heat generated inside the cabinet is removed through
12 The HP POD supports HP or any third-party IT equipment that conforms to 19-inch industry-standard mounting and front-to-back air flow. The only r
13 Cooling decisions based on room layout If facility characteristics allow several cooling options, the rack layout can suggest which cooling strat
14 Managing data center cooling High-density data centers require close monitoring and management to achieve and maintain efficient and economical c
15 Managing the data center environment with HP Environmental Edge HP Environmental Edge technology helps you monitor two critical areas of the data
For more information For additional information, refer to the resources listed below. Resource description Web address HP Rack and Rack Options h
2 Introduction If you’re deploying the latest generation of information technology (IT) equipment or adding more servers to a crowded data center, c
3 Server blade systems and 1U servers let you assemble high-density infrastructures; however, these systems create much more heat per square foot of
4 The increasing heat loads created by the latest server systems require more aggressive cooling strategies than the traditional open-area approach.
5 Air-side economization Air-side economization uses a system of supply and return fans, filters, and dampers that maintain positive air pressure wi
6 Water-side economization Water-side economization uses a cooling tower as either the primary or supplementary means of cooling the chilled water s
7 Cold-aisle containment In a cold-aisle containment system, two ITE rows face front-to-front, with the cold air coming up through vented floor tile
8 Hot-aisle containment In a hot-aisle containment system, two ITE rows are positioned back-to-back. As illustrated in Figure 7, the warm air exhaus
9 Closed-loop cooling systems Closed-loop systems are designed specifically for cooling IT equipment. They are the best solution for high-density sy
Kommentare zu diesen Handbüchern