HP EliteDesk 705 G3 Small Form Factor PC Bedienungsanleitung PDF herunterladen (Seite 29)

Removing and installing drives

When installing drives, follow these guidelines:

●

The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA connector on

the system board labeled SATA0.

●

Connect secondary hard drives and optical drives to one of the light blue SATA connectors on the system

board (labeled SATA1 and SATA2).

●

HP has provided four extra 6-32 hard drive mounting screws installed on the top of the hard drive cage

(1) for installing a hard drive into the 3.5-inch secondary hard drive bay. If you are replacing a hard drive,

remove the mounting screws from the old drive and install them in the new drive.

NOTE: You can also use one of the extra mounting screws to secure the front bezel (see Front bezel

security on page 46 for more information).

IMPORTANT: To prevent loss of work and damage to the computer or drive:

If you are inserting or removing a drive, shut down the operating system properly, turn o the computer, and

unplug the power cord. Do not remove a drive while the computer is on or in standby mode.

Before handling a drive, be sure that you are discharged of static electricity. While handling a drive, avoid

touching the connector. For more information about preventing electrostatic damage, refer to Electrostatic

discharge on page 50.

Handle a drive carefully; do not drop it.

Do not use excessive force when inserting a drive.

Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic elds such as

monitors or speakers.

If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the

package “Fragile: Handle With Care.”

Removing and installing drives 23

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 59 60

Keine Kommentare

HP EliteDesk 705 G3 Small Form Factor PC Bedienungsanleitung Seite 29