Hp StorageWorks 2.32 Edge Switch Bedienungsanleitung PDF herunterladen (Seite 145)

Edge Switch Element Manager user guide 145

1. Select Configure > Preferred Path. The Configure Preferred Paths dialog box appears as shown

in Figure 66. The Configure Preferred Paths dialog box provides the configuration for a single

switch’s preferred path.

Figure 66 Configure Preferred Paths dialog box

NOTE: Some columns may only display when the FICON Management Style feature has

been installed.

The columns included in the dialog box are as follows:

• Source Port—This column lists the source port of the preferred path.

• Source Addr (FICON management style only)—This column lists the source address of the

preferred path.

• Exit Port—This column lists the exit port of the preferred path.

• Exit Addr (FICON management style only)—This column lists the exit address of the

preferred path.

• Destination Domain ID—This column lists the domain ID of the destination switch or director.

The range of the destination domain ID number is 1 through 31.

TIP: You may need to configure preferred paths on multiple switches or directors to optimize load

balancing for an entire path between devices.

NOTE: A warning message will display if the switch or director has not been configured for

insistent domain ID. If this is the case, close the dialog box and select Configure > Operating

Parameters > Switch Parameters. Select the Insistent check box in the Configure Switch Parameters

dialog box. Return to the Configure Preferred Paths dialog box and continue to step 2.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 201 202

Keine Kommentare

Hp StorageWorks 2.32 Edge Switch Bedienungsanleitung Seite 145