HP Vectra VE5 2 Betriebsanweisung PDF herunterladen (Seite 64)

4 Run

Setup

by pressing [F2]. CMOS default values will be automatically downloaded and

saved.

5 Make any other changes you want and press [F3] to save the configuration and exit from

Setup

Power-On-Self-Test Errors that May Prevent Your PC From Starting

Message Corrective Action and/or Explanation

Operating system not found Check whether the disk, HDD, FDD or CD-ROM disk

drive is connected.If it is connected, check that it is

detected by

Setup

, “After Installing an IDE Drive” on page

71.Check that your boot device is enabled on the

Setup

Security menu.If the problem persists, check that the boot

device contains the operating system.

Missing operating system If you have configured HDD user parameters, check that

they are correct. Otherwise, use HDD type “Auto”

parameters.

Failure fixed disk

(preceeded by a 30” time-out)

Check that HDD is connected.Check that HDD is detected

Setup

.Check that boot on hard disk drive is enabled in

Setup

, “The HP Setup Program” (chapte 4).

Diskette Drive A (or B) error Check whether the diskette drive is connected. Check

Setup

for the configuration, “The HP Setup Program”

(chapte 4).

System battery is dead You may get this message if the PC is disconnected for a

few days. When you Power-on the PC, run

Setup

update the configuration information. The message

should no longer be displayed. Should the problem

persist, replace the battery “Changing the Battery” on

page 90.

Keyboard error Check that the keyboard is connected.

Resource Allocation Conflict -PCI device

0079 on motherboard

Clear CMOS. Refer to “Clearing the Battery Backed-Up

Memory (CMOS Memory)” earlier in this chapter.

Video Plug and Play interrupted or failed

Re-enable in Setup and try again

You may have powered your PC Off/On too quickly and

the PC turned off Video plug and play as a protection.

System CMOS checksum bad -

run Setup

CMOS contents have changed between 2 power-on

sessions. Run

Setup

for configuration.

I/O device IRQ conflict Serial ports A and B may have been assigned the same

IRQ. Assign a different IRQ to each serial port and save

the configuration.

No message, system “hangs” after POST Check that cache memory and main memory are

correctly set in their sockets.

Other An error message may be displayed and the PC may

“hang” for 20 seconds and then beep. The POST is

probably checking for a mass storage device which it

cannot find and the PC is in Timeout Mode. After

Timeout, run

Setup

to check the configuration.

IF YOUR PC HAS A HARDWARE PROBLEM

This section describes what to do if you have problems with your display, disk drives, printer,

accessory board, keyboard, or mouse.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 101 102

Kommentare zu diesen Handbüchern

Keine Kommentare

HP Vectra VE5 2 Betriebsanweisung Seite 64

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software HP Vectra VE5 2