HP -UX SNAplus2 Bedienungsanleitung PDF herunterladen (Seite 384)

384 Appendix D

Using SNAplus2 in a High Availability Environment

Advanced Conﬁguration Techniques

commands in the script. The ability to add other SNAplus2 commands

gives you a way to specify local recovery actions before allowing the

script to end.

For example, suppose you want to monitor a Token Ring LS called TRLS.

If it fails, you ﬁrst try to restart TRLS. If TRLS does not restart, you try to

start an SDLC LS called SDLCLS.

Your monitor script might look like this:

#!/bin/ksh

# This script monitors an SNAplus2 package, which uses the

# following SNAplus2 configuration:

# A node is configured to run a Token Ring

# LS, TRLS, and an SDLC LS, SDLCLS. TRLS uses a port

# called TRPORT, and SDLCLS uses a port called SDLCPORT.

# If the primary LS ever fails, the script performs three steps

# to restore SNA network connectivity.

# Step 1: Attempt local restart of TRLS. If successful, monitor

# the LS, then return to Step 1. Otherwise, go to

Step 2.

# Step 2: Attempt local failover to SDLCLS. Monitor the LS

# until it fails, then go to Step 3.

# Step 3: Exit, which will inform ServiceGuard of a complete

# package failure. Service Guard will then perform

# remote failover.

# Add the SNAplus2 command directory to PATH.

PATH=/opt/sna/bin:$PATH

#-------------------------------------------------------------

# STEP 1: Local restart

#-------------------------------------------------------------

# Start (or restart) the primary LS. If local restart is

# successful, then loop back to try it again.

exitcode=0

while (( $exitcode == 0 ))

# Attempt to start the node. If it is already active,

# the command will have no effect.

snapadmin init_node

# Attempt to start the port. If it is already active,

# the command will have no effect.

snapadmin start_port, port_name=TRPORT

1 2 ... 379 380 381 382 383 384 385 386 387 388 389 ... 397 398

Keine Kommentare

HP -UX SNAplus2 Bedienungsanleitung Seite 384