Hp SmartStart-Software Bedienungsanleitung PDF herunterladen (Seite 15)

Deployment options 15

When the firmware update process is completed, the BitLocker Drive Encryption support can be re-

enabled by following steps 1 through 4 but clicking Enabled in step 5 instead. The following command

can be used to re-enable BitLocker Drive Encryption after firmware deployment has completed.

cscript manage-bde.wsf -protectors -enable c:

TPM scenarios

The following table discusses the TPM detection scenarios that you might encounter.

Scenario Result

If the TPM is detected and enabled, the

installation is not silent, and a system ROM must

be updated.

A pop-up warning message appears. After OK is

selected, you can continue. The installation is not

canceled.

If the TPM is detected and enabled, the

installation is silent, the /tpmbypass switch is not

given, and any firmware updated must be

applied to the server.

No pop-up warning appears. A new log file is

generated

(%systemdrive%\cpqsystem\log\cpqstub.log).

Because the installation is silent, the installation is

terminated and cannot continue.

If the TPM is detected and enabled with Option

ROM Measuring, the installation is not silent, and

a system ROM must be updated.

A pop-up warning message appears. After OK is

selected, you can continue. The installation is not

canceled.

If the TPM is detected and enabled with Option

ROM Measuring, the installation is silent; the

/tpmbypass switch is not given, and any firmware

updated must be applied to the server.

No pop-up warning appears. A new log file is

generated

(%systemdrive%\cpqsystem\log\cpqstub.log).

Because the installation is silent, the installation is

terminated and cannot continue.

If the TPM is detected and enabled, the

installation is silent, and the /tpmbypass switch is

supplied.

The installation occurs.

Other scenarios do not affect the normal installation procedure.

Booting a Firmware DVD over a network

This section provides instructions on booting a Firmware DVD over a network.

Prerequisites

The following is required before proceeding with the configuration:

• You must have a good working knowledge of PXE and TFTP.

• A network with a DHCP server on it.

• A TFTP server configured on the same network as the DHCP server.

• A network file server hosting the ISO images and can be accessed by a PXE booted system.

• PXELinux (http://syslinux.zytor.com/wiki/index.php/PXELINUX)

This guide assumes that you are using a Linux TFTP server and the TFTP package

(

http://www.kernel.org/pub/software/network/tftp). Other TFTP servers should work similarly.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 50 51

Kommentare zu diesen Handbüchern

Keine Kommentare

Hp SmartStart-Software Bedienungsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Hp SmartStart-Software