HP Remote Graphics Software (RGS) Bedienungsanleitung PDF herunterladen (Seite 178)

Unless this command line option is used to change the logSetup file, the default logSetup file in the

Sender installation folder (C:\Program Files\Hewlett-Packard\Remote Graphics Sender) is used. The

first few lines of logSetup are shown in

Figure 6-33 Remote Clipboard log entries for cut and paste

on page 158.

Figure 6-35 logSetup file

The highlighted, uncommented line specifies that INFO-level logging is used. If another logging level is

required, edit the file to replace INFO with any of the following: DEBUG, WARN, ERROR, or FATAL.

NOTE: The logSetup file is set to read-only during Sender installation, so you’ll need to uncheck the

Read-only property to edit the file.

NOTE: In order to log Remote Clipboard activities on the Sender, DEBUG-level logging (not the

default INFOlevel logging) must be specified in the logSetup file.

160 Chapter 6 Advanced capabilities ENWW

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 258 259

Keine Kommentare

HP Remote Graphics Software (RGS) Bedienungsanleitung Seite 178