HP Z Virtual Workstation series Bedienungsanleitung PDF herunterladen (Seite 71)

Installing a full-length expansion board

1. Power down the server on page 18.

2. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Extend the server from the rack on page 19.

4. Remove the access panel on page 20.

5. Release the full-length expansion board retainer, and then remove the PCI riser cage.

. Remove the expansion slot cover (

Removing the expansion slot blanks on page 62).

7. Install the expansion board.

. Connect any required internal or external cables to the expansion board. See the documentation

that ships with the expansion board.

Install the PCI riser cage on page 26.

Secure the full-length expansion board retainer on page 27 if any full-length expansion boards

are installed.

Install the access panel on page 20.

12. Install the server into the rack (Installing the server into the rack on page 35).

. Connect each power cord to the server.

. Connect each power cord to the power source.

Power up the server on page 18.

Expansion board options 65

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 110 111

Keine Kommentare

HP Z Virtual Workstation series Bedienungsanleitung Seite 71