HP C5100 Bedienungsanleitung PDF herunterladen (Seite 10)

Finish setting up networking

This section describes how to connect the HP All-in-One to a network and how to view

and manage network settings.

Wired network setup

This section describes how to connect the HP All-in-One to a router, switch, or hub using

an Ethernet cable and how to install the HP All-in-One software for a network connection.

What you need for a wired network

Before you connect the HP All-in-One to a network, make sure you have all of the required

materials.

❑

A functional Ethernet network that includes a router, switch, or hub with an Ethernet

ports.

❑

CAT-5 Ethernet cable.

Although standard Ethernet cables look similar to standard telephone cables, they

are not interchangeable. There is a different number of wires in each one, and each

has a different connector. An Ethernet cable connector (also called an RJ-45

connector) is wider and thicker and always has 8 contacts on the end. A phone

connector has between 2 and 6 contacts.

❑

A desktop computer or laptop with an Ethernet connection.

Note The HP All-in-One supports both 10 Mbps and 100 Mbps Ethernet

networks. If you are purchasing, or have purchased, a network interface card

(NIC), make sure it can operate at either speed.

❑

HP recommends broadband Internet access such as cable or DSL. Broadband

Internet access is required if you want to access HP Photosmart Share directly from

the HP All-in-One.

Basics Guide 7

HP All-in-One overview

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 44 45

Keine Kommentare

HP C5100 Bedienungsanleitung Seite 10