HP 61-in Bedienungsanleitung PDF herunterladen (Seite 44)

17. Fit the loop-shaper into the supports at either side.

18. Use the wind-direction switch on the take-up reel motor to select the winding direction. Setting 1

winds the substrate so that the printed image faces in. Setting 2 winds the substrate so that the

printed image faces out.

The front panel shows you the correct setting based on the winding-direction decision you made

earlier.

19. Press the OK button on the front panel. The Take-up reel has been successfully installed

message appears.

20. The following image shows how the printer looks when it is operating. As substrate is fed from the

printer, it drops down in a loop and then up into the take-up reel spindle.

NOTE: While the take-up reel is operating, make sure that the take-up reel sensors are not blocked.

NOTE: The cutter is disabled when the take-up reel is in use.

40 Chapter 4 Handle the substrate ENWW

Handle the substrate

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 94 95

Keine Kommentare

HP 61-in Bedienungsanleitung Seite 44