Hp 48g Graphing Calculator Bedienungsanleitung PDF herunterladen (Seite 415)

100

101

4. Take any action:

■ To see the next program step displayed in the status area and

then executed, press ;5:5T .

■ To display but not execute the next one or two program steps,

press H £ X T .

■ To continue with normal execution, press S)(CONT],

B To abandon further execution, press KILL .

5. Repeat step 4 as desired.

To single-step from the middle of a program:

1. Insert a HALT command in the program where you want to begin

single-stepping.

2. Execute the program normally. The program stops when the HALT

command is executed, and the HRLT annunciator is displayed.

3. Take any action:

■ To see the next program step displayed in the status area and

then executed, press SST .

a To display but not execute the next one or two program steps,

press HEIKT .

■ To continue with normal execution, press pt^fCONT I.

fl To abandon further execution, press KILL .

4. Repeat step 3 as desired.

When you want the program to run normally again, remove the HALT

command from the program.

To single-step when the next step is a subroutine;

■ To execute the subroutine in one step, press :BST .

■ To execute the subroutine step-by-step, press :BST+ .

S S T executes the next step in a program—if the next step is a

subroutine, :3ST executes the subroutine in one step. :3ST4-

works just like SST —except if the next program step is a

subroutine, it single-stejis to the first step in the subroutine.

To turn off the HAL'." 'annuriCiator a?, anj tKiie;

Press f PRGl C

Programming the HP 48 29-9

1 2 ... 410 411 412 413 414 415 416 417 418 419 420 ... 611 612

Kommentare zu diesen Handbüchern

Keine Kommentare

Hp 48g Graphing Calculator Bedienungsanleitung Seite 415

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für PDAs Hp 48g Graphing Calculator