HP xw6000 Betriebsanweisung PDF herunterladen (Seite 65)

Hardware Reference Guide B–1

Hard Drive Installation

Using the Cable-Select Feature with Ultra ATA

Devices

Selected models of the HP workstation xw6000 have an internal

Ultra ATA hard drive installed. The configuration of the drive

employs a cable-select feature that identifies the drive as

device 0 (primary drive) or device 1 (secondary drive).

Device 1 is the drive connected to the cable’s middle connector.

Device 0 is the drive connected to the cable’s end connector (applies

only to 80-conductor ATA cables). See “Guidelines for Installing

Ultra ATA Devices” in this appendix for an example of an Ultra ATA

cable.

HP hard drives ship with jumpers preset to cable-select mode;

therefore, no jumper setting changes on the existing or optional

drives are required. If you purchase a third-party hard drive, refer to

the documentation included with the kit to ensure proper installation

and configuration of cables.

✎

If installing a second device on the primary controller, you must use

an 80-conductor Ultra ATA cable for optimal performance. This cable

is standard on selected models.

Longbow.book Page 1 Thursday, August 22, 2002 11:38 AM

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 82 83

Keine Kommentare

HP xw6000 Betriebsanweisung Seite 65