Upgrading and Replacing PC Hardware
24
3 Check that the jumpers on the rear of the new drive are set to CS (cable select) mode.
4 Slide the drive in from the front of the PC, aligning it with the drive in place in the shelf above.
5 Tighten the two screws that fasten the drive to the bay.
6 Connect the data and power cables, and for DVD or CD-ROM drives on Linux models, the audio cable.
• If this is the second device installed in the expansion bays, fit the data connector marked SLAVE.
• If this is the only device, fit the end CD connector marked MASTER.
7 Replace the PC’s side panel (refer to “Removing and Replacing the Side Panel” on page 12).
8 Reconnect the power cord.
audio cable (only
required for Linux
models)
Kommentare zu diesen Handbüchern