HP Vectra XE320 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 19)

Upgrading and Replacing PC Hardware

Replacing the Hard Drive

For information on recovering the contents of your old hard drive, refer to the Vectra XE320

Troubleshooting Guide, available in PDF format from the HP Vectra support website

(

www.hp.com/go/vectrasupport

WARNING

For your safety, disconnect the power cord and all external cables.

1 Switch off the PC, disconnect the power cord and remove the PC’s side panel (refer to “Removing and

Replacing the Side Panel” on page 12).

2 Press the tab on the hard drive/floppy drive tray and pull the tray out part of the way.

3 Disconnect the cables at the back of the floppy drive and hard drive.

4 Remove the drive tray from the PC.

5 Remove the three hard drive fixing screws (two on one side of the tray as shown below, and one on the

other side), noting carefully the position of these screws.

Caution

Take care when handling the hard drive. A one-quarter inch drop can damage it.

6 Slide the drive in the direction shown until it is released from the tray, holding the drive tray firmly so

as not to drop it.

Press here

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Keine Kommentare

HP Vectra XE320 Anleitung zur Fehlerbehebung Seite 19