HP E5000 Betriebsanweisung PDF herunterladen (Seite 119)

Removing and replacing the 1210m controller board components

Removing the 1210m controller card

WARNING! Wear gloves or use care when removing the capacitor pack to avoid physical injury.

1. Verify the failed component as described in “Verifying component failure” (page 73).

2. Back up all data.

3. Close all applications.

4. To power off the server blade, click Start, and then select Shut down.

5. Remove the server blade (Figure 134 (page 119)):

a. Push the button to release the handle (1).

b. Pull the handle toward you (2).

c. Remove the server blade from the enclosure (3).

Figure 134 Removing the server blade

6. Press the release button on the access panel and slide the access panel to the left to remove

it.

7. The original cache module is connected to a capacitor pack, so observe the cache module

LEDs:

• If the amber LED is solid, data transfer to the flash device on the cache module is in

progress. Do not remove the cache module until the amber LED is off, and then continue

with the next step.

• If the amber LED is not lit, proceed to the next step.

8. Open the ejector latches (1, Figure 135 (page 119)) on each side of the cache module slot.

Typically, opening the ejector latches ejects the cache module automatically. If the module

does not eject automatically after you open the ejector latches, remove the cache module (2)

by grasping only the edges.

Figure 135 Removing the cache module

Removing and replacing the 1210m controller board components 119

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 198 199

Keine Kommentare

HP E5000 Betriebsanweisung Seite 119