HP 24SII Bedienungsanleitung PDF herunterladen (Seite 25)

Connect the proper serial cable between COMx (where x = 1, 2, 3, or

4) of a PC, or dumb terminal, to Port 1 of Module 1 (the master

configuration port). All other cables can be connected after the system

is configured (see

Section 8





From the factory, the Model 24SII Data Exchange System is set up

with Port 1 of Module 1 (serial) designated as a computer port. Port 1

of Module 1 is the master configuration port and must always be a

serial port. Several parameter settings are set only through this port.

Port 2 of Module 1 (serial) is factory-designated as a printer port. All

other installed ports are factory-designated as computer ports. You

may designate in the configuration mode which ports are computer

ports and which are printer ports if required.

Other factory-default settings are:

Input Inactivity Timeout: 20 seconds

Port Select Code: $SELECT

Port Select Mode: Mode A (printer selection anytime while

printing).

Form Feed Mode: disabled

I.D. Page Message: disabled

Port Logical Name(s): set as Device A, Device B, etc.

Default Printer Assignment: 0 for all computer ports

(contention mode).

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 167 168

Keine Kommentare

HP 24SII Bedienungsanleitung Seite 25