HP 12M Installationshandbuch PDF herunterladen (Seite 24)

2-10

Installing the HP 10/100 Hubs

Installation Procedures

Installing the HP 10/100 Hubs

5. Connect the Network Cables

Connect the network cables, described under “Cabling Infrastructure” (page

2-4), from the network devices or your patch panels to the RJ-45 ports on the

hub.

To connect the cables:

Push the RJ-45 plug into the RJ-45 jack

until the tab on the plug clicks into place.

When power is on for the hub and for the

connected device, the Link LED for the

port should light to confirm a powered-

on device (for example, an end node) is

at the other end of the cable.

If the Link LED does not go on when

the network cable is connected to the

port, see “Diagnosing With the LEDs”

in chapter 3, “Troubleshooting”.

To disconnect:

Press the small tab on the plug and pull

the plug out of the jack.

10X

11 X

12X

RJ-45 plug

Unshielded twisted-pair cable:

• Category 3, 4, or 5 for 10 Mbps ports

• Category 5 only for 100 Mbps ports

Maximum distance: 100 meters

9934.book Page 10 Thursday, January 14, 1999 12:39 PM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 65 66

Keine Kommentare

HP 12M Installationshandbuch Seite 24