HP C110 Bedienungsanleitung PDF herunterladen (Seite 31)

C100_110-160_180.FB 29 Tue Jul 16 06:36:50 1996

Installing the New Main Tray Assembly

8 Reconnect the power cables and any other cables that you disconnected when

opening the workstation.

If you do not have a supported graphics adapter, connect your monitor’s 15-pin

connector to the 15-pin connector on the EVC adapter cable which came with

the upgrade kit. Connect the other end of the EVC adapter cable to the built-in

video connector on the rear of the system. Be sure to tighten the thumbscrews on

the connectors. Continue with step 9.

If you do have a supported graphics adapter, connect the 15-pin monitor connec-

tor directly to the connector on the graphics adapter. Skip to step 19.

9 Power on the monitor, the system, and any peripherals.

10 If your keyboard connects to the PS/2 connector on your system, wait 2 seconds

after the Num Lock light flashes near the end of the boot sequence, then press Tab

to initiate the automatic monitor selection process.

NOTICE: It takes approximately one to two minutes after powering on the

workstation before the Num Lock light ﬂashes.

If you have a keyboard that connects to the HIL connector on your system, press

Tab every three seconds during the boot sequence to initiate the automatic mon-

itor selection process.

1 2 ... 26 27 28 29 30 31 32 33 34

Keine Kommentare

HP C110 Bedienungsanleitung Seite 31