Hp TC2120 Bedienungsanleitung PDF herunterladen (Seite 57)

Chapter 3 Installing and Configuring

System Board Jumper/Dip Switch Settings

You need to change dip switch settings to clear the CMOS or passwords, perform a hardware flash or BIOS

recovery, or when you upgrade from a 400 MHz to 533 MHz processor. The FSB jumper switch must also be

moved when you upgrade to a higher speed processor. The following illustrations indicate switch locations and

default settings.

Figure 3-25. Location of Jumper and Dip Switches

Figure 3-26. Configuration Switch Positions

Configuration

Switches

Reserved Switches

Jumper Switch

Hardware Flash Protection (Enable flash protection when On. Default = Off)

Reserved (Do not change default setting)

Clear CMOS (Active when On. Default = Off)

BIOS Recovery ( Active when On. Default = Off)

Clear Password ( Active when On. Default = Off)

Reserved (Do not change default setting)

Reserved (Do not change default setting

)

Reserved (Do not change default setting)

On (black indicates switch setting)

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 124 125

Keine Kommentare

Hp TC2120 Bedienungsanleitung Seite 57