Hp ML100 Bedienungsanleitung PDF herunterladen (Seite 29)

Extend the server from the rack.

on, see the server installation sheet on the

HP website

Remove the access panel (on page 7).

5. Remove the air baffle.

For more informati

(

http://www.hp.com/go/bizsupport).

6. Open the DIMM slot latches.

7. Install the DIMM.

10. back into the rack.

ll the tower bezel, as needed.

onfigure this mode in

RBSU ("ROM-Based Setup

ooting failed DIMMs, see the server installation sheet on

the

HP website (http://www.hp.com/go/bizsupport).

Expansion board options

For server s with

8. Install the air baffle.

Install the access panel.

For ML110 G6 servers, slide the server

11. For ML150 G6 servers, do one of the following:

o Close or insta

o Slide the server back into the rack.

If you are installing DIMMs in lock-step configuration, c

Utility

" on page 38).

For more information about LEDs and troublesh

-specific expansion board installation instructions, refer to the installation sheet that ship

the server.

CAUTION: To prevent damage to the server or expansion boards, power down the server

alling the expansion boards. and remove all AC power cords before removing or inst

To install the component:

2. rver from the rack.

Power down the server (on page 7).

For ML110 G6 servers, extend the se

Hardware options installation 29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 110 111

Keine Kommentare

Hp ML100 Bedienungsanleitung Seite 29