Hp NonStop G-Series Bedienungsanleitung PDF herunterladen (Seite 14)

Installing and Configuring the Tape Drive for the

NonStop S-Series Server

5243 Tape Drive Installation and User’s Guide—542758-003

2-2

Installation

4. Connect one end of the SCSI cable to the top SCSI port at the rear of the tape

drive. See Figure 2-2 for the location.

5. Hand tighten the screws to secure the cable to the unit.

6. Connect the opposite end of the SCSI cable to the NonStop S-series server.

The tape drive can connect to the ServerNet/DA, IOMF2 CRU, or PMF CRU on

the NonStop S-series server.

You can use any of the SCSI cables listed in Tabl e 2-1.

7. Place a terminator on the bottom SCSI port of the tape drive.

8. Check that the power button on the front of the tape drive is off.

9. Connect the power cord to the AC power receptacle on the rear of the tape drive.

Check that the power cord is fully seated.

Note. The tape drive’s SCSI ID comes preconfigured to SCSI ID 5. If you need to change

the SCSI ID, use a screwdriver. Do not use a lead pencil.

Figure 2-2. Rear View of Tape Drive

Table 2-1. SCSI Cables

Model Number Description

519-003W 3 meter copper SCSI cable

519-015W 15 meter copper SCSI cable

519-020W 20 meter copper SCSI cable

519-023W 23 meter copper SCSI cable

AC Power Receptacle Fan SCSI Ports SCSI ID

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Keine Kommentare

Hp NonStop G-Series Bedienungsanleitung Seite 14