Hp Netserver L Server series Bedienungsanleitung PDF herunterladen (Seite 86)

Chapter 8 Rack Mounting the HP Netserver (2-Post)

Preparing the HP Netserver

Before the HP Netserver can be mounted in the rack, you need to remove the

factory-installed chassis slides from the Netserver and install the flush-mount or

center-mount brackets.

1. Lay the HP Netserver on a flat surface.

2. Remove the slides from the sides of the chassis. See Figure 8-3.

Figure 8-3. Removing Existing Hardware

3. If you are center-mounting the HP Netserver, remove the center spacers

(attached to the chassis under the slides). See Figure 8-3.

4. If you are flush-mounting the HP Netserver, remove front bezel and the front

brackets. See Figure 8-3.

Do not remove the front brackets if you are center-mounting the HP

Netserver. In this case, the front brackets are needed to attach the bezel.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 145 146

Keine Kommentare

Hp Netserver L Server series Bedienungsanleitung Seite 86