Hp Multi-Site Traffic Director sa9200 Bedienungsanleitung PDF herunterladen (Seite 99)

C H A P T E R 6 Configuration Commands

telnet-sessions

NOTE: If you set the

number of sessions to 0,

you are disabling all future

Telnet sessions to the

SA9200. To reset Telnet,

you must access the device

through the serial port and

Telnet session count from

0, to a number from 1 to 8

Sets the allowable number of concurrent inbound remote CLI

Syntax:

config CLI telnet-sessions <nsessions>

where:

nsessions is the number of allowed sessions (0 to 8). The

default number of sessions is 0. .

timeout

NOTE: Too small of a

timeout value renders the

CLI useless.

Sets or changes the idle timeout period before automatic logout

for CLI sessions. The timeout value can be set to 0, which

specifies no timeout

. To set a value, use the range 30 to 65535

seconds.

Syntax:

config CLI timeout <seconds>

where:

seconds is the timeout period in seconds (0, or a range of 30 to

65535). The default is 900 seconds (15 minutes).

Command Description

Config CLI Commands

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 207 208

Keine Kommentare

Hp Multi-Site Traffic Director sa9200 Bedienungsanleitung Seite 99