Hp Integrity rx4610 Server Bedienungsanleitung PDF herunterladen (Seite 43)

Chapter 4 Installing Mass Storage Devices

3. Disconnect the drive’s data and power cables from the drive cable adapter

PCB at the rear of the drive.

4. Loosen the thumbscrew found at the rear of the drive carrier assembly.

5. Slide the drive and drive carrier assembly towards the rear of the chassis so

that the front part of the drive clears the opening in the chassis.

6. Place the drive in an antistatic protective wrapper if you are not reinstalling

the same drive.

Installing the DVD Drive

To install the new DVD drive, complete the following steps:

1. Remove the new drive from its protective wrapper, and place it face down

on an antistatic surface.

2. Record the drive model and serial numbers in your equipment log.

3. Pick up the DVD drive and drive carrier assembly and place it face up

(carrier side down) on the chassis such that the front of the drive is aligned

with the opening in the front of the chassis.

Figure 4-4. Installing the DVD

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 248 249

Keine Kommentare

Hp Integrity rx4610 Server Bedienungsanleitung Seite 43