HP HyperFabric Betriebsanweisung PDF herunterladen (Seite 168)

Troubleshooting HyperFabric

Determining Whether a Switch is Faulty

Chapter 6154

Determining Whether a Switch is Faulty

If you suspect that a HyperFabric switch is faulty, follow the steps below

to determine if the switch needs replacing.

HF2 Switch

The steps for determining if an HF2 switch is faulty are as follows:

Step 1. Check the cards/switch module in the switch—the integrated Ethernet

management LAN adapter card, integrated 8-port ﬁber card, and switch

module in the expansion slot:

a. If the card/switch module is functioning correctly, its

“Operating/Fault” LED shows as solid green.

b. If the card/switch module is experiencing a fault, its

“Operating/Fault” LED shows as solid yellow.

c. If the card/switch module is not operating, its “Operating/Fault” LED

is off.

Step 2. Check the switch’s power:

a. If the power to the switch is on, the “Power A” and “Power B” LEDs

both show as solid green.

b. If only one of the “Power” LEDs shows as solid green, the switch is

still operational. However, the integrated Ethernet management LAN

adapter card should be replaced soon. (Remember, it can be replaced

by qualiﬁed HP personnel only.)

c. If both “Power” LEDs are off, the enclosure (the power supply,

backplane, and fan-monitoring board) must be replaced by qualiﬁed

HP personnel only.

Step 3. Check the switch’s Ethernet ports:

a. If the port is connected to an operational Ethernet network, the port’s

LED (“Ethernet Port Main” or “Ethernet Port Aux”) shows as solid or

blinking green.

b. If the port is disconnected, or connected to an Ethernet network that

is not operational, the port’s LED is off.

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 189 190

Keine Kommentare

HP HyperFabric Betriebsanweisung Seite 168