HP Value 2D Wireless Scanner Bedienungsanleitung PDF herunterladen (Seite 36)

Reading parameters

Point the scanner at the target and pull the trigger to enable the aiming system and the illuminator (red

beam) to decode the barcode label. The aiming system will briefly switch off during the acquisition time and

if no code is decoded will switch on again before the next acquisition. The illuminator will remain on until the

symbol is decoded.

As you read code symbols, adjust the distance at which you are holding the scanner.

Aiming system

A number of options for customizing control of the Aiming System are available. See the Programming

Reference Guide (PRG) for more information and programming bar codes.

Good read green spot duration

Successful reading can be signaled by a good read green spot.

Use the bar codes that follow to specify the duration of the good read pointer beam after a good read.

Figure 5-2 ENTER/EXIT PROGRAMMING MODE

Figure 5-3 Green Spot Duration = Disable (Green Spot is Off)

Figure 5-4 Green Spot Duration = Short (300 msec)

Figure 5-5 Green Spot Duration = Medium (500 msec)

Figure 5-6 Green Spot Duration = Long (800 msec)

30 Chapter 5 Programming the scanner

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Keine Kommentare

HP Value 2D Wireless Scanner Bedienungsanleitung Seite 36