HP Value 2D Wireless Scanner Bedienungsanleitung PDF herunterladen (Seite 23)

The useful life of LI batteries depends on usage and number of charges, etc., after which they should be

removed from service, especially in mission critical applications. Do not continue to use a battery showing

excessive loss of capacity, it should be properly recycled / disposed of and replaced.

Collect and recycle waste batteries separately from the device to comply with European Directive 2006/66/

EC, 2011/65/EU, 2002/96/EC, 2012/19/EU and subsequent modifications, US and China regulatory and other

laws and regulations about the environment.

Replacing the battery pack

NOTE: Before proceeding, read “Battery Safety” on the preceding pages. HP recommends annual

replacement of rechargeable battery packs to ensure maximum performance.

Use the following procedure to change the reader’s battery:

1. Unscrew the bottom of the battery pack until it is disengaged.

Figure 4-11 Battery Pack Screw

The battery pack will rise slightly in the rear, pushed by the contact springs.

2. Extract the battery pack by slightly rotating the pack and pulling it away from the scanner.

Figure 4-12 Extracting the Battery Pack

To mount the new battery pack reverse the process:

1. Insert the top of the new pack inside the scanner’s handle.

2. Rotate the battery pack downward while pressing the bottom side of the battery pack (to seat securely

into the contacts springs) so that the edges of the pack and the handle board are aligned, while

replacing the screw in the bottom of the handle.

Replacing the battery pack 17

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

Keine Kommentare

HP Value 2D Wireless Scanner Bedienungsanleitung Seite 23