HP ProDesk 600 G4 Base Model Small Form Factor PC Bedienungsanleitung PDF herunterladen (Seite 50)

Serial connector module

Follow these steps to remove the serial connector module:

1. Prepare the computer for disassembly (see Preparation for disassembly on page 28).

2. Remove the access panel (see Access panel on page 29), and then remove the following components:

a. Front bezel (see Front bezel on page 31)

b. Drive cage (see Drive cage on page 34)

c. Shroud (see Fan shroud on page 38)

Remove the serial connector module:

1. Disconnect the serial connector module cable (1) from the system board.

2. Remove the two 3/16-in. screw locks (2) that secure the serial connector module to the computer chassis.

3. Remove the serial connector module (3).

Reverse this procedure to install the serial connector module.

42 Chapter 4 Removal and replacement procedures

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 123 124

Keine Kommentare

HP ProDesk 600 G4 Base Model Small Form Factor PC Bedienungsanleitung Seite 50