HP Elite Slice for Meeting Rooms Bedienungsanleitung PDF herunterladen (Seite 17)

Removing modules

CAUTION: Before disconnecting modules, turn o the Elite Slice and disconnect it from any power source.

Modules cannot be “hot-plugged” or “hot-swapped.”

Modules must be removed one at a time, starting at the bottom. Removing the bottom module exposes the

release latch of the module above it.

1. Remove/disengage the security cable, if one is attached.

2. Remove all removable media, such as USB ash drives.

3. Turn o the Elite Slice properly through the operating system, and then turn o any external devices.

4. Disconnect the power cord from the Elite Slice and disconnect any external devices.

5. If the VESA plate is connected, slide the quick release latch on the back of the VESA plate to the unlocked

position and lift the module stack o the VESA plate.

6. Beginning at the bottom, remove additional modules by pressing the release latch (1) on the underside

of each module until it releases the module (2) above it.

Connecting power

The Elite Slice can be connected to a powered port on an HP monitor or it can be connected to an AC outlet

using the HP adapter that shipped with the Elite Slice. Power sources not obtained from HP will be rejected.

NOTE: Under certain power-loading conditions, some USB ports may be temporarily disabled to meet

product safety regulations.

Connecting power 11

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

Keine Kommentare

HP Elite Slice for Meeting Rooms Bedienungsanleitung Seite 17