Hp XP External Storage Software Bedienungsanleitung PDF herunterladen (Seite 104)

Figure 48 Example of Using Continuous Access or Continuous Access Journal with

Remote C

ommand Device

Procedure to Use Initiator/External MIX Mode

This section describes the procedure to use the Initiator/External MIX mode and the procedure to stop

using the Initiator/External MIX mode.

Theprocedure to usethe Initiator/External MIXmodeisasfollows:

1. Prepare the initiator ports of the Standard mode and external ports of the Standard mode in

one port block.

For procedure to set the port attribute to initiator, see the HP StorageWorks XP24000 Continuous

Access Software User and Reference Guide or the HP StorageWorks XP24000 Continuous

Access Journal Software User and Reference Guide.

For procedure to set the port attribute to external, see

“Setting Port Attribute for Local Storage System” on page 68.

2. Set the Initiator/External MIX mode to the port block consisting of the initiator ports of the

Standard mode and external ports of the Standard mode.

For procedure to set the Initiator/External MIX mode, see the HP StorageWorks XP24000 LUN

Manager User’s Guide.

3. Connect the cable to the port, and connect a storage system to be used as an MCU and local

storage system and a storage system to be used as an RCU and external storage system.

4. Map the command device as the remote command device.

Note:

Only the command device can be recognized when the discovery operation is performed

using the external port of the Initiator/External MIX mode.

104

Remote Command Devices

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 137 138

Keine Kommentare

Hp XP External Storage Software Bedienungsanleitung Seite 104