Hp Storage Mirroring Software Bedienungsanleitung PDF herunterladen (Seite 150)

Job monitoring Page 149 of 214

Viewing the statistics file

The statistics log file created is a binary file. To view the log file, you must run the DTStat

utility from a command prompt. From the directory where Storage Mirroring Replicate is

installed, run the DTStat command.

Command

DTSTAT

Description

Starts the DTStats statistics logging utility from a command prompt

Syntax

DTSTAT [-p][-i <interval>][-t <filename>] [-f <filename>] [-s <filename>] [-

st <filename>][-IP <address>] [-START <mm/dd/yyyy hh:mm>][-STOP

<mm/dd/yyyy hh:mm>] [-SERVER <ip_address> <port_number>]

Options

l -p—Do not print the output to the screen

l -i interval—Refresh from shared memory every interval seconds

l -t filename—Save the data from memory to the specified binary file

filename

l -f filename—Reads from a previously saved binary file, filename, that

was generated using the -t option instead of reading from memory

l -s filename—Saves only the connection data from the data in memory

to an ASCII, comma-delimited file, filename

l -st filename—Saves only the target data from the data in memory to an

ASCII, comma-delimited file, filename

l -f filename1 -s filename2—Saves only the connection data from a

previously saved binary file, filename1, to an ASCII, comma-delimited

file, filename2

l -f filename1 -st filename2—Saves only the target data from a

previously saved binary file, filename1, to an ASCII, comma-delimited

file, filename2

l -IP address—Filters out the specified address in the IP address field

and prints only those entries. Specify more than one IP address by

separating them by a comma.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 214 215

Keine Kommentare

Hp Storage Mirroring Software Bedienungsanleitung Seite 150