HP 100B SFF Betriebsanweisung PDF herunterladen (Seite 48)

2-38 www.hp.com Hardware Reference Guide

Hardware Upgrades

9. Pull the green tab that locks the drive in place away from the

drive 1, slide the hard drive toward the front of the computer,

then lift the drive up and out of the bay 2.

Removing the Hard Drive

10. To install a hard drive, reverse the above procedure.

✎

If the system has only one SATA hard drive, the data cable must be

connected to the blue connector labeled P60 SATA 0 on the system

board to avoid any hard drive performance problems.

✎

When replacing the hard drive, transfer the four screws from the old

drive to the new one. The screws take the place of drive rails. You will

need a Torx T-15 screwdriver to remove and re-install the guide

screws. HP has provided four extra 6-32 standard guide screws on the

front of the chassis, under the computer cover. The 6-32 standard

guide screws are silver.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 72 73

Keine Kommentare

HP 100B SFF Betriebsanweisung Seite 48