HP RX2600 Bedienungsanleitung PDF herunterladen (Seite 22)

Version 1.2 Page 8 4/22/04

Select Active Standard Error Devices

Cold Reset

Exit

Timeout-->[10] sec SystemGuid-->[C198BA79-478A-11D7-9C22-

6033AC66036B]

SerialNumber-->[US30464638 ]

Step 3

Select each of the consoles and set the active console device. Use either "v" "^" or !

". For this example, we will change only the console output device. When you select

the output device, you receive a display something like the one below:

EFI Boot Maintenance Manager ver 1.10 [14.61]

Select the Console Output Device(s)

Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(PcAnsi)

Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100)

Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100+)

Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(VtUtf8)

Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(PcAnsi)

* Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(Vt100)

Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(Vt100+)

Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(VtUtf8)

Acpi(HWP0002,700)/Pci(2|0)

Save Settings to NVRAM

Exit

Step 4

Using either the "v" "^" or ! ", move to the device you want to select or deselect.

Pressing the Space bar changes the state, and the asterisk (*) indicates what is

selected. In the above list, the Management Processor is selected and set to emulate a

VT100. If you select Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100), the

console is the BMC console labeled as console/serial A on the back of the system.

Step 5 After making your changes, select the "Save Setting to NVRAM" and then exit.

Step 6 Repeat Steps 4 and 5 for the output and error devices.

Step 7 Finally, perform a cold reset of the system. If you changed the console from MP to

the BMC or vice versa, you may need to move the serial cable to the appropriate

connector on the system.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 83 84

Keine Kommentare

HP RX2600 Bedienungsanleitung Seite 22