HP RX2600 Bedienungsanleitung PDF herunterladen (Seite 39)

Version 1.2 Page 25 4/22/04

Transfer Of Control

TC: System reset through INIT or TOC (Transfer of Control) signal

Under normal operation, shut down the operating system before issuing this command.

This command causes the system to be reset through the INIT (or TOC) signal. Execution of this command

irrecoverably halts all system processing and I/O activity and restarts the computer system. It is different

from the RS command in that the processors are signaled to dump state on the way down.

Tell

TE: TEll—sends a message to other terminals.

Up to 80 characters can be typed in. The message is broadcast to the other mirrored clients. Users in a

session or CSP are not shown the message.

User Configuration

UC: User Configuration—controls user access

This command allows an Administrator to add, modify, re-enable, or delete user logins. The Administrator

can also enable or disable security warnings and change passwords.

Virtual Front Panel

VFP: Display Virtual Front Panel

When invoked, this command displays a current summary of system status, including the state of front

panel LEDs.

There are two ways that the live display of events can be started:

1. Live Mode: Invoked from the VFP command at the MP prompt. To exit, type Q to quit the

console.

2. Early Boot Mode: When the boot sequence for the system begins, the live VFP is invoked

automatically. When boot finishes, you are automatically switched to console mode.

The LED state reflects the state of the front panel LEDs. When system power is off, the remote LED shows

“off” even thought remote access may be enabled with the EL or ER commands.

Who

WHO: Displays a list of MP connected users.

This command displays the login name and operating mode (Main Menu, command, etc.) of the connected

console client users and the port on which they are connected. For the LAN and WEB console clients the

remote IP address is also displayed.

If the local console client user did not originate the MP command Interface session, there is always one

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 83 84

Keine Kommentare

HP RX2600 Bedienungsanleitung Seite 39