HP ZBook 17 G2 Mobile Workstation Bedienungsanleitung PDF herunterladen (Seite 108)

Power connector cable

NOTE: The power connector cable is included in the Cable Kit, spare part number 785212-001.

Before removing the power connector cable, follow these steps:

1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the

computer on, and then shut it down through the operating system.

2. Disconnect all external devices connected to the computer.

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and

then unplugging the AC adapter from the computer.

4. Remove the battery (see Battery on page 41).

5. Remove the service cover (see Service cover on page 43).

6. Remove the optical drive (see Optical drive on page 52) or upgrade bay hard drive (see Upgrade Bay

hard drive on page 54).

7. Remove the keyboard (see Keyboard on page 57).

8. Remove the top cover (see Top cover on page 67).

9. Remove the display assembly (see Display assembly on page 77).

10. Remove the graphics subsystem heat sink (see Graphics subsystem heat sink on page 91).

Remove the power connector cable:

1. Remove the Torx T8M2.5×7.0 screw (1) that secures to the rear corner cover/left to the base enclosure.

2. Remove the rear corner cover/left (2).

The rear corner cover/left is available in the Plastics Kit, 733637-001.

3. Remove the Torx T8M2.5×4.0 screw (3) that secures to the power connector bracket.

4. Remove the power connector bracket (4).

The power connector bracket is available in the Bracket Kit, spare part number 737734-001.

5. Disconnect the power connector cable from the system board (5).

96 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 170 171

Keine Kommentare

HP ZBook 17 G2 Mobile Workstation Bedienungsanleitung Seite 108