Hp ZBook 15 Mobile Workstation Bedienungsanleitung PDF herunterladen (Seite 93)

Use the arrow keys to select File > Save Changes and Exit, and then press enter.

Your changes go into effect when the computer restarts.

Entering MultiBoot Express preferences

When the Express Boot menu is displayed during startup, you have the following choices:

●

To specify a boot device from the Express Boot menu, select your preference within the allotted

time, and then press enter.

●

To prevent the computer from defaulting to the current MultiBoot setting, press any key before

the allotted time expires. The computer will not start until you select a boot device and press

enter.

●

To allow the computer to start according to the current MultiBoot settings, wait for the allotted

time to expire.

Using HP PC Hardware Diagnostics (UEFI) (select models

only)

HP PC Hardware Diagnostics is a Unified Extensible Firmware Interface (UEFI) that allows you to run

diagnostic tests to determine if the computer hardware is functioning properly. The tool runs outside

of the operating system to isolate hardware failures from issues that may be caused by the operating

system or other software components.

To start HP PC Hardware Diagnostics UEFI:

1. Turn on or restart the computer, quickly press esc, and then press f2.

After pressing f2, the BIOS searches three places for the HP PC Hardware Diagnostics (UEFI)

tools in the following order:

a. Connected USB drive

NOTE: To download the HP PC Hardware Diagnostics (UEFI) tool to a USB drive, see

Downloading HP PC Hardware Diagnostics (UEFI) to a USB device on page 84.

b. Hard drive

c. BIOS

2. Click the type of diagnostic test you want to run, and then follow the on-screen instructions.

NOTE: If you need to stop a diagnostic test while it is running, press esc.

Using HP PC Hardware Diagnostics (UEFI) (select models only) 83

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 107 108

Keine Kommentare

Hp ZBook 15 Mobile Workstation Bedienungsanleitung Seite 93