Hp ProLiant DL360 G5 Server Bedienungsanleitung PDF herunterladen (Seite 26)

Setup 26

Rack planning resources

The rack resource kit ships with all HP branded or Compaq branded 9000, 10000, and H9 series racks.

For more information on the content of each resource, refer to the rack resource kit documentation.

If you intend to deploy and configure multiple servers in a single rack, refer to the white paper on high-

density deployment at the HP website (http://www.hp.com/products/servers/platforms

Optimum environment

When installing the server in a rack, select a location that meets the environmental standards described in

this section.

Space and airflow requirements

To allow for servicing and adequate airflow, observe the following space and airflow requirements when

deciding where to install a rack:

• Leave a minimum clearance of 63.5 cm (25 in) in front of the rack.

• Leave a minimum clearance of 76.2 cm (30 in) behind the rack.

• Leave a minimum clearance of 121.9 cm (48 in) from the back of the rack to the back of another

rack or row of racks.

HP servers draw in cool air through the front door and expel warm air through the rear door. Therefore,

the front and rear rack doors must be adequately ventilated to allow ambient room air to enter the

cabinet, and the rear door must be adequately ventilated to allow the warm air to escape from the

cabinet.

CAUTION: To prevent improper cooling and damage to the equipment, do not block the ventilation

openings.

When vertical space in the rack is not filled by a server or rack component, the gaps between the

components cause changes in airflow through the rack and across the servers. Cover all gaps with

blanking panels to maintain proper airflow.

CAUTION: Always use blanking panels to fill empty vertical spaces in the rack. This arrangement ensures

proper airflow. Using a rack without blanking panels results in improper cooling that can lead to thermal

damage.

The 9000 and 10000 Series Racks provide proper server cooling from flow-through perforations in the

front and rear doors that provide 64 percent open area for ventilation.

CAUTION: When using a Compaq branded 7000 Series rack, you must install the high airflow rack door

insert [P/N 327281-B21 (42U) or P/N 157847-B21 (22U)] to provide proper front-to-back airflow and

cooling.

CAUTION: If a third-party rack is used, observe the following additional requirements to ensure adequate

airflow and to prevent damage to the equipment:

• Front and rear doors—If the 42U rack includes closing front and rear doors, you must allow 5,350 sq

cm (830 sq in) of holes evenly distributed from top to bottom to permit adequate airflow (equivalent to

the required 64 percent open area for ventilation).

• Side—The clearance between the installed rack component and the side panels of the rack must be a

minimum of 7 cm (2.75 in).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 117 118

Keine Kommentare

Hp ProLiant DL360 G5 Server Bedienungsanleitung Seite 26