HP EliteDesk 800 G2 Small Form Factor PC Bedienungsanleitung PDF herunterladen (Seite 62)

Hood sensor

The hood sensor is attached to the rear of the chassis.

1. Prepare the computer for disassembly (Preparation for disassembly on page 18).

2. Remove the access panel (Access panel on page 19).

3. Rotate the small bae into the upright position (Small bae on page 48).

4. Disconnect the hood sensor cable from the system board connector labeled HSENSE.

5. Slide the hood sensor out of the slot on the rear of the chassis (2). A tool such as a screwdriver may be

required to disengage the hood sensor from the slot.

To install the hood sensor, reverse the removal procedure.

52 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 153 154

Keine Kommentare

HP EliteDesk 800 G2 Small Form Factor PC Bedienungsanleitung Seite 62