HP 16501A LOGIC Bedienungsanleitung PDF herunterladen (Seite 62)

8 Record the differences shown by the two modules.

You can use the X and O markers to measure the differences in delays.

9 Select the Intermodule Menu.

10 Select Skew, then enter a skew correction value for one of the

modules using the knob or the keyboard.

11 Return to the module waveform display and recheck the skew

adjustment.

You will need to repeat steps 7 through 11 as needed until the trigger events

on the two waveforms match as closely as possible.

Before making an intermodule measurement, you should remove skew between

the modules to ensure that a simultaneous arm signal to both modules results in

captures of the same events around the trigger.

Skew Removal Between Timing Analyzer and Oscilloscope

Intermodule Measurements

To adjust for minimum skew between two modules involved in an intermodule

measurement

2–28

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 129 130

Keine Kommentare

HP 16501A LOGIC Bedienungsanleitung Seite 62