Hp StorageWorks Scalable File Share Bedienungsanleitung PDF herunterladen (Seite 40)

1. Install the Lustre source RPM as provided on the HP SFS G3.1-0 software tarball in the

/opt/hp/sfs/SRPMS directory. Enter the following command on one line:

# rpm -ivh lustre-source-1.6.7-2.6.18_92.1.17.el5_lustre.1.6.7smp.x86_64.rpm

2. Change directories:

# cd /usr/src/linux-xxx

3. Copy in the /boot/config-xxx for the running/target kernel, and name it .config.

4. Run the following:

# make oldconfig

5. Change directories:

# cd /usr/src/lustre-xxx

6. Configure the Lustre build. For example, on one command line (replacing with different

versions if needed):

NOTE: The --with-o2ib option should be used for InfiniBand systems only.

# ./configure --with-linux=/usr/src/linux-2.6.16.46-0.12/ \

--with-linux-obj=/usr/src/linux-2.6.16.46-0.12-obj/x86_64/smp \

--with-o2ib=/usr/src/ofa_kernel

7. Run the following command:

# make rpms 2>&1 | tee make.log

8. When successfully completed, the newly built RPMs are available in /usr/src/packages/

RPMS/x86_64. Install them according to the “Installation Instructions” (page 38).

9. For InfiniBand systems, add the following line to /etc/modprobe.conf.local:

options lnet networks=o2ib0

For 10 GigE systems, add the following line to /etc/modprobe.conf:

options lnet networks=tcp(eth2)

In this example, eth2 is the Ethernet interface that is used to communicate with the HP SFS

system.

40 Installing and Configuring HP SFS Software on Client Nodes

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 69 70

Keine Kommentare

Hp StorageWorks Scalable File Share Bedienungsanleitung Seite 40