Hp StorageWorks DAT 72x10 Tape Autoloader Bedienungsanleitung PDF herunterladen (Seite 33)

Table 8 B ackward read compatibility

DAT 72, 170 meter DDS-4, 150 m eter DDS-3, 125 meter

72 GB*

, C8010A

40 GB

,C5718A 24 GB

, C5708A

Read/Write Read/Write Read/Write

assumes 2:1 compression

NOTE:

Although HP DAT 72x10 Tape Autoloaders are fully backward compatible, old tape formats are more

abrasive than later generations and using older tape formats can reduce the life expectancy of the device.

Magazines

The HP StorageWorks DAT 72x10 1U Tape Autoloader has t wo removable magazines. For safety

reasons, the robotic motion is stopped when a magazine is removed. You will not be able to use the

autoloader until you have replaced the magazine correctly.

The magazines can be released using the Operator Control Panel (OCP) or by a manual release.

recommends that you release the magazine using the OCP. The magazine must only be

removed manually when the O CP process has failed, or the autoloader no longer has power. See

“Releasing the magazines manually” on page 56.

Theslotnumbering scheme is shownin Figure 14 for the left magazine, and Figure 15 for the right

magazine.

Figure 14 Slot numbering left m agazine

Figure 15 Slot numbering right ma g azine

Inserting car tridges in a magazine

1. Push the cartridge gently into the magazine slot. It will click when it is seated properly.

2. When the magazine is fully loaded, shake it gently. All cartridges should remain securely seated

and

ﬂushwiththe end stops.

DAT 72x10 1U Tape Autoloader

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 61 62

Keine Kommentare

Hp StorageWorks DAT 72x10 Tape Autoloader Bedienungsanleitung Seite 33