Hp StorageWorks 3000 RAID Array Bedienungsanleitung Seite 104

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 112
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 103
4-6 RAID Array 3000 Controller Shelf Hardware Users Guide
Compaq Confidential Need to Know Required
Writer: Bob Young Project: RAID Array 3000 Controller Shelf Hardware Users Guide Comments:
Part Number: EK-SMCPQ-UG. D01 File Name: e-ch4 Second Controller Option.doc Last Saved On: 12/4/00 1:08 PM
6. Select menu item (2), Change serial baud rate. Select 38400. When
presented with the Please change your baud rate and press Return message,
do so from within HyperTerminal via the File\Properties menu, then select
Configure. If there is no response from the utility after changing the baud
rate, proceed with step 7.
7. After changing the baud rate, you may have to close and re-enter
HyperTerminal. Press the Return key after HyperTerminal restarts. You will
see the FLASH Boot Utility Option menu again.
8. Select menu item (1) Download new Firmware Image. Using the Transfer
menu in HyperTerminal, choose Send Text File and send the firmware. You
should see a Receiving code for System Version <ver> message, followed
by a series of \ | / - characters cycling at the end of the line. At 9600 baud, the
download will take between 45-60 minutes. At 38400, it should take around
10-12 minutes. At completion, you will see the FLASH Programming
Complete message, followed by the FLASH Boot Utility Options menu
again.
9. Select item (9), Restart Controller. You will be instructed to reset the baud
rate back to 9600, which you will again do from the HyperTerminal File
\Properties\Configure menu. As in step 7 you will probably have to exit and
restart HyperTerminal to get any response. Press Enter when HyperTerminal
restarts.
10. Your firmware should now be upgraded.
Shutting down the RA3000
1. Ensure that both host ports are in a quiescent state (no I/O activity).
2. Shut down the Host System.
3. Issue a shutdown command from the SWCC Console to the controller shelf.
4. Power Off the controller shelf.
Seitenansicht 103

Kommentare zu diesen Handbüchern

Keine Kommentare